Often it is necessary to output some lists one after another in a report. Stimulsoft Reports has no restrictions on it. All you have to do to render such a report is to place two Data bands with headers and footers bands. For example.

 

Put two Data bands on a page, specify them with different data sources. In addition create a header and a footer for the Data band. For this, place two Header bands and two Footer bands. How do you know which header and footer bands belong to the Data band? It's very simple. The Header band should be placed over the Data band. The Footer band should be placed under the Data band. Thus, the Header band or the Footer band are considered to belong to this Data band, if there are no other Data bands between them. For example, two bands of each type are placed on a page. The HeaderBand1 band is placed over the DataBand1 and there are no other Data bands between them. So it belongs to the DataBand1. But if to take the DataBand2, then between this band and the HeaderBand1 band the DataBand1 is placed. Therefore, the HeaderBand1 does not belong to the DataBand2. The FooterBand1 is placed under the DataBand1 band and there are no other Data bands between them. So it belongs to the DataBand1. But the FooterBand2 band is placed under the DataBand1, and the DataBand2. But there is the DataBand2 in placed between the DataBand1 and the FooterBand2. Therefore, the FooterBand2 belong the the DataBand2. Here is an example of a report template, which outputs several lists one after another.

 

 

The first Data band will output the first list. When the list will be output the second list will be output. The second band will output on the second list. The number of lists is unlimited. The picture below shows the sample of how to output a report with with two lists.