Series of the chart component are the main element of the diagram. Series are important to visualize data. It should be understood that construction is not possible without series of the diagram.

 

 

The toolbar contains the basic commands to control the chart series: adding series, deleting the selected one, moving the selected series in the list.

 

NOTICE: If the chart type is defined on the Chart tab, in the menu of adding rows, only series of this type will only be available, and those that can interact with the type of a chart. If the chart type is not specified, the type of a chart will depend on the selected series.

 

The list of chart series. As can be seen from the picture, this chart contains three rows.

The preview panel. This panel displays the chart and immediately previews changes made in real time.

The list of group of parameters of the tab Series:

The group Common. You can find settings for the selected series. Among them are data source, data, etc.

The group Conditions. Here you can set parameters for the selected series.

The group Filter. Parameters of filtering of the selected series can be set here.

The group Interaction. Here you can setup interaction of the series.

The group TopN. In this group you can set maximum or minimum values​​.

The group Series Labels. This group of parameters are used to define position, rotation for series labels etc.

 

Information: Various displaying modes of series labels can be applied in the chart series - Show Series Labels: From Series and Show Series Labels: From Chart. The mode is defined in the tab Labels in the group of properties Series Labels.

If the mode Show Series Labels: From Series is enabled, then on the tab Series, the group Series Labels you should define the type of labels. In this mode, you can specify a particular type of labels for each series.

If the mode Show Series Labels: From Chart is enabled then the type of series labels will be the same as selected in the tab Labels. For example, you have a chart with 10 series in it and labels should have the same style, which means the same type. In this case, on the tab Labels, you can define the type and in settings of each series you can specify the mode Labels From Chart.